HowTo: Change Speed and Duplex of Ethernet card in Linux

To change Speed and Duplex of an ethernet card, we can use ethtool – a Linux utility for Displaying or Changing ethernet card settings.

1. Install ethtool

You can install ethtool by typing one of the following commands, depending upon your Linux distribution.

Install ethtool in Fedora, CentOS, RHEL etc.:

# yum install ethtool

Install ethtool in Ubuntu, Debian etc.:

# sudo apt-get install ethtool

2. Get the Speed, Duplex and other information for the interface eth0

To get speed, duplex and other information for the network interface eth0, type the following command as root.

# ethtool eth0

Sample output:

Settings for eth0:
	Supported ports: [ MII ]
	Supported link modes:   10baseT/Half 10baseT/Full 
	                        100baseT/Half 100baseT/Full 
	                        1000baseT/Half 1000baseT/Full 
	Supports auto-negotiation: Yes
	Advertised link modes:  10baseT/Half 10baseT/Full 
	                        100baseT/Half 100baseT/Full 
	                        1000baseT/Half 1000baseT/Full 
	Advertised auto-negotiation: Yes
	Speed: 100Mb/s
	Duplex: Half
	Port: Twisted Pair
	PHYAD: 1
	Transceiver: internal
	Auto-negotiation: on
	Supports Wake-on: g
	Wake-on: d
	Current message level: 0x000000ff (255)
	Link detected: yes

3. Change the Speed and Duplex settings

The following changes are temporary and they’ll stop working after reboot. Read the next section, to make settings permanent.

The next command enables Auto-Negotiate feature:

# ethtool -s eth0 autoneg on

The next command disables Auto-Negotiation, enables Half Duplex and sets up Speed to 10 Mb/s:

# ethtool -s eth0 speed 10 duplex half autoneg off

The next command disables Auto-Negotiation, enables Full Duplex and sets up Speed to 100 Mb/s:

# ethtool -s eth0 speed 100 duplex full autoneg off

4. Change the Speed and Duplex settings Permanently on CentOS/RHEL

To make settings permanent, you need to edit /etc/sysconfig/network-scripts/ifcfg-eth0 file for eth0 interface. This file is used by RHEL, CentOS, Fedora etc.

# vi /etc/sysconfig/network-scripts/ifcfg-eth0

Append the line as follows to disable Auto-Negotiation, enable Full Duplex and set up Speed to 100 Mb/s:

ETHTOOL_OPTS="speed 100 duplex full autoneg off"

Restart the interface to apply changes:

# ifdown eth0 && ifup eth0
 
  • 0 Los Usuarios han Encontrado Esto Útil
¿Fue útil la respuesta?

Artículos Relacionados

What Is My Router’s IP Address (Default Gateway)

A router is a device that communicates between the Internet (or public network) and the devices...

CIDR Notation – Explained & Examples

CIDR (Classless Inter-Domain Routing) notation is a compact method for specifying IP addresses...

Disable IPv6 on Linux – Ubuntu, Debian, CentOS

To disable IPv6 on Linux it is required to modify Linux kernel parameters. IPv6 can be temporary...

169.254.0.0/16 – Disable ZEROCONF Route

You may notice that in your routing table you have a route 169.254.0.0/16. It is so called...

What is my Public IP address?

Use one of the following commands to check your public IP address from the Linux command line....