Change Network Interface Name: eth0,eth1,eth2+

The best way to rename a network interface is through udev.

Edit the file /etc/udev/rules.d/70-persistent-net.rules to change the interface name of a network device.

The names of the network devices are listed in this file as follows:

# PCI device 0x11ab:0x4363 (sky2)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*",
ATTR{address}=="00:00:00:00:00:00",ATTR{dev_id}=="0x0", ATTR{type}=="1",
KERNEL=="eth*", NAME="eth0"

Rename network interface from eth0 to wan0

To rename interface eth0 to wan0, edit /etc/udev/rules.d/70-persistent-net.rules file and change NAME="eth0" to NAME="wan0".

# PCI device 0x11ab:0x4363 (sky2)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*",
ATTR{address}=="00:00:00:00:00:00",ATTR{dev_id}=="0x0", ATTR{type}=="1",
KERNEL=="eth*", NAME="wan0"

For Centos/RHEL etc.

Rename the network interface configuration file:

# cd etc/sysconfig/network-scripts/
# mv ifcfg-eth0 ifcfg-wan0

Edit the network interface configuration file and replace all occurrences of the old name eth0 with the new one wan0:

# vi /etc/sysconfig/network-scripts/ifcfg-wan0

For Ubuntu etc.

Edit the /etc/network/interfaces file and replace all occurrences of the old name eth0 with the new one wan0:

# sudo nano /etc/network/interfaces

Test changes

Reboot the system to test changes:

# reboot

Verify new settings:

# ifconfig -a

Rename network interface from eth1 back to eth0

Q: Why does my network interface name change?
A: The interface name of a network device increases if the MAC address of a network card changes.

Edit the file /etc/udev/rules.d/70-persistent-net.rules.

Copy the new MAC address from eth1 to the line of your eth0 rule.

Delete the rule for eth1. Save and close the file.

For Centos/RHEL etc.

Check the network interface configuration located under:

# vi /etc/sysconfig/network-scripts/ifcfg-eth0

Don’t forget to replace the old MAC address with the new one.

For Ubuntu etc.

Make sure /etc/network/interfaces file has correct configuration:

# sudo nano /etc/network/interfaces

Test changes

Reboot the system to test changes:

# reboot

Verify new settings:

# ifconfig -a
  • 0 Корисниците го најдоа ова како корисно
Дали Ви помогна овој одговор?

Понудени резултати

What Is My Router’s IP Address (Default Gateway)

A router is a device that communicates between the Internet (or public network) and the devices...

CIDR Notation – Explained & Examples

CIDR (Classless Inter-Domain Routing) notation is a compact method for specifying IP addresses...

Disable IPv6 on Linux – Ubuntu, Debian, CentOS

To disable IPv6 on Linux it is required to modify Linux kernel parameters. IPv6 can be temporary...

169.254.0.0/16 – Disable ZEROCONF Route

You may notice that in your routing table you have a route 169.254.0.0/16. It is so called...

What is my Public IP address?

Use one of the following commands to check your public IP address from the Linux command line....